5x10mm Thin Shim Washers Stainless Steel 40pc 0.1-0.5mm 5mm ID

5x10mm Thin Shim Washers Stainless Steel 40pc 0.1-0.5mm 5mm ID

✅ In stock

Grade

💤 Not a Deal

11.8/100

Current Price

$11.99

Listed $59.99

Save $48.00 80% OFF

Analysis Confidence 73%

⚠️ Price may have changed. Last updated 24+ hours ago — confirm on Amazon.

Check Deal at Amazon

Price verified Sep 19, 2026 6:39 AM · Prices & availability subject to change

Is This a Good Price on Amazon?

💤 Not a Deal

💤Verdict: Not a Deal. Price is at or above historical norms. Best to wait for a sale.
💰The current price is slightly above the going rate for this product — worth watching for a drop.
🏷️The retail sticker price has been slashed by 80% — a steep markdown from the official listing.
📉This is the most affordable price seen in roughly three months — a solid near-term opportunity.
➡️Pricing has held fairly steady, with no strong push in either direction.

How We Scored This Deal

Price Competitiveness 0/28

Recent Value 0/22

Market Standing 0.8/20

Deal Strength 7/20

Momentum 4/10

📝 Product Overview

🏪 Sold by Plasmagal

📦 Fulfillment Fulfilled by Amazon

🚚 Shipping Free Shipping

Product Details

✓40 PIECES, 4 THICKNESSES: 10 each of 0.1mm, 0.2mm, 0.3mm and 0.5mm. Stack them to reach any gap from 0.1mm up to 1.1mm in 0.1mm steps, so one kit covers the full adjustment range instead of ordering a single size and hoping it fits.

✓EXACT 5 x 10 mm SIZE: 5mm inner diameter, 10mm outer diameter, DIN 988 precision shim washers. Measure your shaft before ordering, this listing is the 5x10mm size only. Other inner and outer diameters are available in the same range.

✓STAINLESS STEEL THROUGHOUT: corrosion resistant material, not plated mild steel. Holds up in gearboxes, engine bays and humid workshops without rusting or staining the parts it sits against.

✓DEBURRED AND FLAT: tight tolerance shim washers with clean, deburred faces that sit flush instead of cocking the part. For bearing preload, end float, pulley alignment and squaring up assemblies where a flat washer is too thick.

✓RC, MOTORCYCLE AND WORKSHOP USE: shims for RC car and truck builds, motorcycle and starter motor spacing, small bearing preload on 5mm shafts, plus general machine and linkage packing.